Sensor Specification
Construction material 316 Stainless Steel for use in a radiation environment with 10metres of PUR submersible cable. At the end of this 10metre cable attached is a small in-line amplifier, in a waterproof enclosure.
Attached to the other end of the amplifier enclosure is a further 1 metre of submersible cable for outdoor use. The amplifier enclosure is over sleeved with heat shrink sleeving to make it suitable for use in an outdoor environment
- Sensor body stainless steel
- Stainless steel flush-fitting diaphragm, with diaphragm connecting directly to the strain gauge (no intermediate fluid fill)
- Measuring range 0 to 10 bar g
- Overpressure capability 15.9 bar g
- Pressure reference sealed gauge, sealed at 1 BarA (0 BarG)
- 3/4 inch BSP parallel fitting, with minimum 2 spanner flats for tightening, plus groove and copper washer to effect a process seal to a 3/4 inch BSP socket
- Sensor to be rated to IP68 to allow permanent immersion in water up to 6m depth
- Amplifier remote from sensor - mounted in line with cable, suitable for permanent outdoor environment
- Amplifier output 4 - 20 mA three wire (equivalent to 0 - 10 BarG)
- Unvented polyurethane cable between sensor and amplifier - 10 metre length
- Additional cable between amplifier and customer's termination point 1m
- Temperature range: -20°C to +80°C
For more details of our sensors suitable for use in the nuclear industry contact our sales team on:
+44 (0)845 9000 601